project izzo

Locked
uberkevin
Posts: 848
Joined: Fri Jun 28, 2013 5:12 pm

Re: project izzo

#121

Post by uberkevin » Tue Nov 05, 2013 6:17 pm

Fuckskee!!!

I'm really glad under my dash didn't look that bad.

Glad you got it taken care of though. Looks good man! :thumbs:
Top
User avatar
izzo
Site Admin
Posts: 5651
Joined: Wed Jun 26, 2013 6:32 pm
Title: Save a pimp, Rent a bitch.
Cars: Too many
Location: Astoria, OR
Contact:
Contact izzo

Re: project izzo

#122

Post by izzo » Thu Nov 14, 2013 9:53 pm

Got an alignment done today, since the PO didn't after he raised it :| All better
Got my stereo installed. Got some tunes now!
8========D ~~~ ( o Y o )
jayden71: titty ponk
devilsbullet wrote: 1400 obo. and best offer doesn't mean 300 bucks you cheap bastards
Top
User avatar
flatcat19
Posts: 5233
Joined: Thu Jun 27, 2013 11:53 am
Title: AKA Smoke
Cars: Smaller. Better. Slower. Lower.
Location: Where you aren't.
Has thanked: 12 times
Been thanked: 32 times

Re: project izzo

#123

Post by flatcat19 » Thu Nov 14, 2013 10:00 pm

What?!?
I can't hear you over all that awesome.
Top
MicroMachinery
Posts: 418
Joined: Thu Jun 27, 2013 4:57 pm

Re: project izzo

#124

Post by MicroMachinery » Thu Nov 14, 2013 10:13 pm

Image
Top
User avatar
izzo
Site Admin
Posts: 5651
Joined: Wed Jun 26, 2013 6:32 pm
Title: Save a pimp, Rent a bitch.
Cars: Too many
Location: Astoria, OR
Contact:
Contact izzo

Re: project izzo

#125

Post by izzo » Thu Nov 14, 2013 10:19 pm

Seriously. Who raises a lowered ride? Something aint right with that, yo!
8========D ~~~ ( o Y o )
jayden71: titty ponk
devilsbullet wrote: 1400 obo. and best offer doesn't mean 300 bucks you cheap bastards
Top
User avatar
izzo
Site Admin
Posts: 5651
Joined: Wed Jun 26, 2013 6:32 pm
Title: Save a pimp, Rent a bitch.
Cars: Too many
Location: Astoria, OR
Contact:
Contact izzo

Re: project izzo

#126

Post by izzo » Fri Nov 22, 2013 5:17 pm

welded in some D rings by the wheel wells, easier to tie the bike down this way. Kinda small, but will hold 300lbs of load each. I just put enough force to hold the bike from tipping/leaning or worse falling out :|
8========D ~~~ ( o Y o )
jayden71: titty ponk
devilsbullet wrote: 1400 obo. and best offer doesn't mean 300 bucks you cheap bastards
Top
User avatar
izzo
Site Admin
Posts: 5651
Joined: Wed Jun 26, 2013 6:32 pm
Title: Save a pimp, Rent a bitch.
Cars: Too many
Location: Astoria, OR
Contact:
Contact izzo

Re: project izzo

#127

Post by izzo » Fri Dec 06, 2013 10:14 am

on way to work
Image
Image

Everyone keeps calling in 'can't make it'

i drive a lowered datsun with street tires.. I fucking made it. sideways, and almost lost it, but i made it. so with that, they sent me home, only to come back and close since all the other fucks called out.

Image
Image
8========D ~~~ ( o Y o )
jayden71: titty ponk
devilsbullet wrote: 1400 obo. and best offer doesn't mean 300 bucks you cheap bastards
Top
User avatar
Jamee
Posts: 1749
Joined: Mon Jul 01, 2013 1:42 pm
Title: Fluffer
Cars: 1977 Datsun B210
Location: Washington
Has thanked: 3 times
Been thanked: 10 times

Re: project izzo

#128

Post by Jamee » Sat Dec 07, 2013 1:32 pm

izzo wrote:on way to work
Image



I LOVE driving while its snowing, it makes me feel like My B is now a spaceship and im blastin through space. :rofl:
:boobs:
Top
Jake from Statefarm
Posts: 13
Joined: Sun Aug 25, 2013 4:42 pm
Location: The Office of Statefarm

Re: project izzo

#129

Post by Jake from Statefarm » Sat Dec 07, 2013 2:04 pm

Hmmm....driving on icy roads and taking pics and posting them on a forum???

Hope you got good insurance policy buddy.
She sounds hideous!
Top
User avatar
izzo
Site Admin
Posts: 5651
Joined: Wed Jun 26, 2013 6:32 pm
Title: Save a pimp, Rent a bitch.
Cars: Too many
Location: Astoria, OR
Contact:
Contact izzo

Re: project izzo

#130

Post by izzo » Sat Dec 21, 2013 7:41 pm

:fry: Not sure if clutch is slipping or tires spinning..... Oh haha, its the tires.. Light ass truck
8========D ~~~ ( o Y o )
jayden71: titty ponk
devilsbullet wrote: 1400 obo. and best offer doesn't mean 300 bucks you cheap bastards
Top
User avatar
izzo
Site Admin
Posts: 5651
Joined: Wed Jun 26, 2013 6:32 pm
Title: Save a pimp, Rent a bitch.
Cars: Too many
Location: Astoria, OR
Contact:
Contact izzo

Re: project izzo

#131

Post by izzo » Tue Mar 18, 2014 5:57 pm

busted finger, broken toe... still managed to replace bal joints today. I hurt so bad,,, havent even been to dr yet. still in lots of pain and crooked finger n busted toe.

baller :D

took 6 hours. got both sides done. aligbnment tomorrow

Image
Image
Image
Image
8========D ~~~ ( o Y o )
jayden71: titty ponk
devilsbullet wrote: 1400 obo. and best offer doesn't mean 300 bucks you cheap bastards
Top
dislexicdime
Posts: 133
Joined: Sat Jun 29, 2013 9:44 pm
Location: tigard oregon

Re: project izzo

#132

Post by dislexicdime » Tue Mar 18, 2014 6:55 pm

Man it took me so long just to get one balljoint off my 86 I still need to do the other 3
kittens and bj's
Top
User avatar
flatcat19
Posts: 5233
Joined: Thu Jun 27, 2013 11:53 am
Title: AKA Smoke
Cars: Smaller. Better. Slower. Lower.
Location: Where you aren't.
Has thanked: 12 times
Been thanked: 32 times

Re: project izzo

#133

Post by flatcat19 » Tue Mar 18, 2014 6:58 pm

You guys need bigger hammers.
Top
User avatar
izzo
Site Admin
Posts: 5651
Joined: Wed Jun 26, 2013 6:32 pm
Title: Save a pimp, Rent a bitch.
Cars: Too many
Location: Astoria, OR
Contact:
Contact izzo

Re: project izzo

#134

Post by izzo » Tue Mar 18, 2014 7:01 pm

dislexicdime wrote:Man it took me so long just to get one balljoint off my 86 I still need to do the other 3


its actually quite easy to do them one side at a time. I was pretty shocked. more than I thought but not as bad.

i removed caliper, hung it, removed last bolt holding steering to it...

Loosened the castle nuts, then ball joint nuts... then used a 5 lb hammer to loosen ball joints from knuckle. then everything just popped out... easy as shit.

I did leave one bolt in the tension control rod thru the lower control arm at all times, however i could have removed them and it would not have popped out of place.... install was easy... clean surface of where ball joint boot hits the knuckle, then put it all back together... tomorrow is alignment and its done... steering is tight now
8========D ~~~ ( o Y o )
jayden71: titty ponk
devilsbullet wrote: 1400 obo. and best offer doesn't mean 300 bucks you cheap bastards
Top
Doctoraudio
Posts: 103
Joined: Fri Dec 20, 2013 9:28 am
Cars: 1969 Datsun 510 wagoon
Location: Milwaukie, Oregon

Re: project izzo

#135

Post by Doctoraudio » Wed Mar 19, 2014 7:52 am

Be careful today could be the day you drop the jack on the other toe!

LOL!
Top
User avatar
izzo
Site Admin
Posts: 5651
Joined: Wed Jun 26, 2013 6:32 pm
Title: Save a pimp, Rent a bitch.
Cars: Too many
Location: Astoria, OR
Contact:
Contact izzo

Re: project izzo

#136

Post by izzo » Sun Mar 23, 2014 11:37 am

well

at my grandpas funeral yesterday i tried talking to the guy that got my grandpas truck. i dont know if he is going to let it go or not. it has sentimental value to him as well. its just sitting and rotting away. my other uncles ganged up on him with me and told him to let me have it. he's owned it for 7-8 years and its just sat. the body is getting bad. He asked if i knew how to wrench... So i talked some with him, and he let me know it would need a motor... but didn't mention anything about letting it go. I really want it.. my grandpa owned it since 66, and its a 1964 model pickup...

Gah man... I don't want it for just some quick money. I would die with this thing.. As in, no way it would ever be sold. I want it for my own memories, and to start restoring it. it pisses me off its been setting that long and he won't do anything with it... "Going to restore it one day"..... just rotting away :(

It's all i can think about anymore...
8========D ~~~ ( o Y o )
jayden71: titty ponk
devilsbullet wrote: 1400 obo. and best offer doesn't mean 300 bucks you cheap bastards
Top
User avatar
izzo
Site Admin
Posts: 5651
Joined: Wed Jun 26, 2013 6:32 pm
Title: Save a pimp, Rent a bitch.
Cars: Too many
Location: Astoria, OR
Contact:
Contact izzo

Re: project izzo

#137

Post by izzo » Mon Mar 24, 2014 6:19 pm

so because of the ball joints needing replaced it killed the driver front tire a little. not bad, still has tread. But They should be replaced.

So I priced out new tires. 177-250 bucks. So I bought a datsun instead. Should arrive tomorrow. It has good wheels and tires on it, just no motor or trans. Going to go thru it a little and make sure things are tits, like brakes, electrical, then stuff my motor and trans in it.
8========D ~~~ ( o Y o )
jayden71: titty ponk
devilsbullet wrote: 1400 obo. and best offer doesn't mean 300 bucks you cheap bastards
Top
User avatar
izzo
Site Admin
Posts: 5651
Joined: Wed Jun 26, 2013 6:32 pm
Title: Save a pimp, Rent a bitch.
Cars: Too many
Location: Astoria, OR
Contact:
Contact izzo

Re: project izzo

#138

Post by izzo » Thu Mar 27, 2014 2:43 pm

Image
Image
Image
8========D ~~~ ( o Y o )
jayden71: titty ponk
devilsbullet wrote: 1400 obo. and best offer doesn't mean 300 bucks you cheap bastards
Top
User avatar
Taterhead
Posts: 2465
Joined: Thu Jul 11, 2013 4:18 am
Cars: '71 510 - Mine
'72 510 - Sons
Location: Central Alabama
Has thanked: 1320 times
Been thanked: 222 times

Re: project izzo

#139

Post by Taterhead » Fri Mar 28, 2014 10:46 am

This truck is more motivation for me to try to swindle a coworker out of his '83 king cab. So far he ain't budging.
Top
User avatar
izzo
Site Admin
Posts: 5651
Joined: Wed Jun 26, 2013 6:32 pm
Title: Save a pimp, Rent a bitch.
Cars: Too many
Location: Astoria, OR
Contact:
Contact izzo

Re: project izzo

#140

Post by izzo » Fri Mar 28, 2014 12:11 pm

I am on the hunt for a 720 king cab. i miss them. they are so roomy, rear jump seats. FUCK YEAH. They look good, too. Surely do miss my ST. it was so clean
8========D ~~~ ( o Y o )
jayden71: titty ponk
devilsbullet wrote: 1400 obo. and best offer doesn't mean 300 bucks you cheap bastards
Top
Locked

Return to “Project Builds”